Ideal Logic Air fault 7
No heat pump starts exceeded
Heat pumpWhat it means
The number of heat pump start attempts has exceeded the allowed limit.
Likely causes
- Repeated failed start attempts
- Underlying fault preventing successful start
- Dwelling room temperature dropped to ≤8°C
- Dwelling ambient temperature at or below 8°C
- Ambient air temperature at or below 1°C
Where to start
- Identify 'Alarm' symbol to indicate a plant error
- Identify 'Maintenance/Special operations' symbol for maintenance message or special operation feedback
- Identify 'Event' symbol for event message from the plant
The full answer, free
- 20 more checks in order
- The readings and component tests from the manual
- How to put it right, step by step
- The manual page for this fault (page 103), right under the answer
Safety: Isolate the outdoor unit and any backup heater, and give the inverter capacitors time to discharge before you open the electrics. Anything on the refrigerant circuit needs F-gas certification.
From the Ideal manual for the Logic Air. Check the model on the data plate before you order parts.
Other Ideal Logic Air fault codes
- 134Re-occurring heat pump fault
- 366Room temp sensor fault
- 370-F15Heat pump air flow fault
- 370-F24Circulation pump error
- 370-F27No water flow fault
- 370-F3Heat pump inverter fault
- 370-F4Outdoor electrical filtering fault
- 370-F9Heat pump defrost thermistor fault
- 9.1.12BSB short circuit fault
- 9.1.16Source temperature too low fault
- 9.1.24Low mains voltage fault
- 9.1.26No outdoor connection fault
- 9.1.28Number of heat pump starts exceeded
- 9.1.29No central heating but hot water works OK